3 Use your TV
Switching on your TV and putting it in
standby mode
Remote control
To turn the TV on from standby or off to standby
●
Press
B
on the unit or the remote control.
Note(s)
●
Energy consumption contributes to air and water pollution. When the
AC power cord is plugged in, your TV consumes energy with a very low
standby power consumption.
Adjusting volume
Remote control
To decrease or increase volume
●
Press VOL +/– on the remote control.
VOL +: Volume up
VOL –: Volume down
To mute or unmute sound
●
Press
V
on the remote control to mute the sound.
●
Press
V
again or VOL + to recover the original sound.
Switching channels
Remote control
To select channels by using CH +/–
●
Press CH +/– on the remote control.
To select channels by using the Number keys
Digital TV operation
●
For
digital channels, press a number followed by a dot “•” and
the corresponding sub channel number.
–
When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable/NTSC (Analog) TV operation
–
When selecting cable or analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
●
To select the non-memorized channels, use the Number keys.
●
NO
SIGNAL will appear on the TV screen after the subchannel broadcast
is over.
●
Audio Only message will appear on the TV screen, when you receive only
a sound signal.
16 .English
Continued on next page.
Back to Contents
To Next Page
Loading...
