Installing the stands
1
Fasten the stand to the TV with 4 screws.
●
While
fastening the screws, hold the stand to prevent it from
falling.
●
Both stands should now be securely fastened.
Note(s)
●
Make sure to use a table which can support the weight of this unit and
is larger than this unit.
●
Make sure the table is in a stable location.
●
A
Phillips head screwdriver is required to fasten the stands to the TV set.
●
When attaching the stand, ensure that all screws are tightly fastened. If
the stand is not properly attached, it could cause the unit to fall, resulting
in injuries as well as damage to the unit.
●
To remove the stand from this unit, unscrew the Phillips head screws by
reversing the procedure. Be careful not to drop the stand when you
remove it.
Installing the remote control batteries
AAA (1.5 V) x 2
1
Slide the battery cover off the back of the remote control.
2
Insert the two included batteries (AAA, 1.5V). Be sure the
+ and – ends of the batteries line up with the markings
inside the case.
3
Slide the cover back into position.
Note(s)
●
Remove the batteries if not using the remote control for an extended
period of time.
8 .English
Continued on next page.
Back to Contents
To Next Page
Loading...
