6-1 PL19.00INT
HOW TO INITIALIZE THE LCD TV
The purpose of initialization is to place the set in a new out of box condition. The customer will be prompted to
select a language and program channels after the set has been initialized.
To put the program back at the factory-default, initialize the LCD TV using the following procedure.
Note: Disconnect any device from the USB Port
before you conduct on this procedure.
Please use the:
Remote Control Unit (Philips Smart)
1. According to above steps, enter into the service
mode.
- To cancel the service mode, press [ ] button on
the remote control unit.
2. Press [Red], [2], [7], [3] buttons to implement
forced the initialized.
3. Make sure to confirm the “INITIALIZED FINISH”
appears in the green screen.
4. Unplug the AC Cord and plug it back on again.
To Next Page
Loading...
