7-1 PL19.00-A_FW
FIRMWARE RENEWAL MODE
Equipment Required
a. USB storage device
b. Remote Control Unit (ROKU)
Firmware Update Procedure
User Upgrade (Filename example: update.roku)
Upgrade the firmware only. The setting values will not be initialized.
Update procedure
Please use the: Remote Control Unit (ROKU)
1. Turn the power on.
2. Insert the USB storage device to the USB port as
shown below.
3. Reset Roku TV.
4. Press the [ ] button, Home - Setting - System -
Advanced system settings - Factory reset, enter
into - Factory reset everything.
5. Insure TV must connect the network, press the
[ ] × 5, [ ], [ ], [ ], [ ], and [ ] enter into
wifi connect interface.
6. Enter into Roku update interface, press the [ ]
button × 5, [ ] × 4, and [ ] × 1 enter into Roku
update interface.
USB port
Rear Cabinet
(example)
USB storage
device
Factory reset everything
Please enter code **** to reset
everything to original factoru
settings and remove all accounts.
2
Reset TV audio/picture settings
Ro
K
u TV
| Factory reset
Options
3 1
5 6 4
8 9 7
0
OK
Wireless
Wired (Ethernet)
Checking connection
Wireless
Wired (Ethernet)
Update connection
Set up new wireless connection
status
connection type
IP address
Wireless MAC address
Signal strength
Wireless channel
Connented
Wireless
***.***.**.**
**:**:**:**:**:**
Excellent
6
Network name
*******
"
*
" differs depending on the models.
To Next Page
Loading...
