EN 48
Channel decoder
NonPubli sh
Before using a SCART digital channel
decoder, select the channel to decode and
assign the decoder to the SCART connector.
1. Press
.
2. Select [Setup] > [Advanced channel
settings] or [Advanced satellite settings] >
[Channel installation] > [Decoder] >
[Channel].
3. Set the channel you want to decode.
4. Select [Status], then the location of the
decoder.
5. Press OK.
PC
NonPubl ish
Connect a computer using one of the following cables:
HDMI cable
DVI-HDMI cable
To Next Page
Loading...
