Philips 34B2U5600C - Page 9

7
Note
Please contact Philips service hotline for
Mac address clone tool as necessary.
5
USB hub
To comply with International energy
standards, the USB hub/ports of this
monitor are disabled during Standby
and Off modes.
Connected USB devices will not work in
this state.
To permanently put the USB function in
the “ON” state, please go to OSD Menu,
then select “USB standby mode”, and
switch it to the “ON” state. Somehow
if your monitor resets to the factory
setting, ensure to select “USB standby
mode” to “ON” state in the OSD menu.
6
USB charging
This display has USB ports capable
of standard power output including
some with USB charging functions
(identifiable with power icon ). You
can use these ports to charge your
Smartphone or power your external
HDD, for example. The display must be
powered ON at all times to be able to
use this function.
Some selected Philips displays may not
Power or Charge your device when it
enters “Sleep/Standby” mode (White
power LED blinking). In that case, please
enter to OSD Menu and select “USB
Standby Mode”, then, turn the function
to “ON” mode (default=OFF). This will
then keep the USB power and charging
functions active even when the monitor
is in sleep/standby mode.


 
 

 
  



Note
If you Turn OFF your monitor via the
power switch at any given time, all the
USB ports will power OFF.
Warning
USB 2.4Ghz wireless devices, such
as wireless mice, keyboards, and
headphones, may result in decreased
eciency of radio transmission of USB
3.2 or higher version of devices. Should
this happen, please try the following
methods to help reduce the eects:
• Try to keep USB 2.0 receivers away
from a USB 3.2 or higher version of
connection port.
• Use a standard USB extension cable
or USB hub to increase the space
between your wireless receiver and
the USB 3.2 or higher version of
connection port.