Philips 43PUT6504/56 - Setting the Option Code

• By using the CLEAR command in the Factory mode:
• By using the following key sequence on the remote control transmitter: “062599” directly followed by the OK button.
• If the contents of the error buffer have not changed for 50 hours, the error buffer resets automatically.
Note: If you exit SAM by disconnecting the mains from the television set, the error buffer is not reset.
5.3 Set Option Code
Press the following key sequence on a standard RC transmitter: “062598” directly followed by MENU and “xxx”, where “xxx” is a 3 digit decimal value
of the panel type: see column “Set Option Code” in below tab. After resetting the Display Code, restart the set immediately.
CTN_ALT BOM# Panel Type
Panel ID
CTN_ALT BOM# Panel Type
Panel ID
50PUT6604/79 TPT500B5-U2T01.D S01G TBD 58PUT6604/79 TPT580B5-U1T01.D S01E TBD
50PUT6604/98 TPT500B5-U2T01.D S01G TBD 58PUT6604/98 TPT580B5-U1T01.D S01E TBD
55PUT6784/56 TPT550J1-QUBH84.K SD9P0AG TBD 65PUT6784/56 TPT650J1-QUBF90.K S9WP1H TBD
55PUT6784/68 TPT550J1-QUBH84.K SD9P0AF
TBD
65PUT6784/75 TPT650J1-QUBF90.K S9WP1H TBD
55PUT6784/70 TPT550J1-QUBH84.K SD9P0AF
TBD
65PUT6784/79 TPT650J1-QUBF90.K S9WP1H TBD
55PUT6784/98 TPT550J1-QUBH84.K SD9P0AG
TBD
65PUT6784/98 TPT650J1-QUBF90.K S9WP1H TBD