Settings > Sound > EasyLink 2.0 > Sound style.
Switch between the preset sound styles. There are
ideal styles for watching movies, listening to music, or
other sound contents.
• Movie - Ideal sound style for watching movie.
• Music - Optimised for listening to music.
• Voice - Enhanced the dialog in the vocals.
• Stadium - Gives a feel of a large open-air stadium.
• Custom - Personalised sound mode.
Adjust bass level
Settings > Sound > EasyLink 2.0 > Bass.
Press the arrows (up) or (down) to
adjust the level of bass.
Adjust treble level
Settings > Sound > EasyLink 2.0 > Treble.
Press the arrows (up) or (down) to
adjust the level of treble.
Custom Equaliser
Settings > Sound > EasyLink 2.0 > Custom
Equaliser.
Adjustable frequency bands when the Sound style is
set to Custom. Press the arrows (up)
or (down) to adjust the level of AI Equalizer.
Surround Sound
Settings > Sound > EasyLink 2.0 > Surround
Sound.
Select a surround effect from the preset types.
• Upmix - Upmix to take full advantage of all
speakers.
• Standard - Speakers output follow the original
channels.
• Surround AI - Optimum surround effect using AI
analysis.
DRC
Settings > Sound > EasyLink 2.0 > DRC.
Select the preferred Dynamic Range Control (DRC).
• Auto - Dynamic range is automatically adjusted.
• On - Optimize the dynamic range.
• Off - Turn off dynamic range adjustment.
Height speakers
Settings > Sound > EasyLink 2.0 > Height
speakers.
Select the preferred height speakers movement.
• Auto - Dynamic movement follow contents.
• On - Always elevated.
• Off - Flat position.
Select sound stage
Settings > Sound > EasyLink 2.0 > Sound stage.
Select a listening experience.
• Auto - Dynamic setting follow contents.
• On - Immersive Sound Stage, good for watching
movies.
• Off - Crystal Sound Stage, good for listening to
music and dialogue.
Reset all to default
Settings > Sound > EasyLink 2.0 > Reset all to
default.
Reset all the EasyLink 2.0 sound settings back to the
original factory settings.
Room Calibration
Room calibration
Settings > Sound > Room calibration.
This calibration will allow the display to determine
the acoustics in your room and provide optimized
sound quality on the display speakers that best
match the acoustics.
You need to pair your remote control with
the display before starting the setup and make sure
the display Audio out setting is Display
speakers. For a more accurate result, please keep the
room quiet.
To start the room calibration…
1 - Hold your remote control at the listening position
and point it towards the display during the tuning
process.
2 - Select Calibrate now or Calibrate again to start
the calibration.
3 - A test sound will be played and measured
through your remote control. Hold your remote
control and point it towards the display, this can take
several seconds.
4 - Once your display speakers are successfully
calibrated, select Test to listen to the sound before
and after the display speakers are calibrated. Select
Apply to accept the setting or select Try again to redo
the calibration.
5 - When room calibration setup is successful and
35
To Next Page
Loading...
