Philips 48OLED707/96 - Clock, Region, and Language Settings

After that, you may need to power off your game
computer or game console and power on again to
complete the first time setup.
Auto Film Mode
Enter the settings for the Auto film mode
 Settings > General settings > Auto film Mode.
Set the method of detection
 Settings > General settings > Auto Filmm Mode >
Film detection.
Select Off, From content or From AI detection to set
how to detect the movie content and then set the
Picture style automatically.
Set preferred Picture style
 Settings > General settings > Auto Filmm Mode >
Preferred Picture style.
Select Filmmaker Mode or Home Cinema for the
Picture style that automatically set when movie
contents is detected.
OLED Screen Settings
Local image protection
 Settings > General
settings > Advanced > OLED screen settings >
Local image protection.
Set the level of protection when local still image is
displayed.
Displaying a still image for a prolonged period of time
may cause an image sticking. This phenomenon is
normal character for OLED panel. Avoid displaying a
fixed image on the screen for an extended length of
time.
Clear residual image
 Settings > General
settings > Advanced > OLED screen settings >
Clear residual image.
When you encounter image residual, you can clear
such image retention on-screen by activating this
function.
1 - Select Settings > General settings and
press  (right) to enter the menu.
2 - Select Advanced > OLED screen settings
> Clear residual image.
3 - Select Confirm.
The display will be switched off until the process is
completed.
If you turn the display on during the process, it will be
stopped and will be restarted automatically when the
display switches to standby at a later time.
While processing, a white line may appear on the
screen. This is normal when clearing on-screen image
retention.
Clear residual image is a deep refreshing process, it is
not for residual image prevention. It shall be manually
operated only when residual image is seen on screen
even after display is in standby mode for at least 8
hours.
Reset Settings and Reinstall
Reset all settings value to original settings
 Settings > General settings > Factory settings.
Redo full installation , and set the status back to the
first time you switch on
 Settings > General settings > Reinstall display.
Enter PIN code and select Yes, the reinstall will be
completed.
All settings will be reset.
The installation can take a few minute
12.6
Clock, Region, and Language
Settings
Menu language
Change the language of the menu and messages
 Settings > All settings > Region and language
> Menu language.
Clock
 Settings > Region and language > Clock.
Correct clock automatically
 Settings > Region and
language > Clock > Auto clock mode.
• The standard setting for the clock is Automatic. The
time information comes from the broadcasted UTC -
39