Y Pb Pr
Y Pb Pr - Component Video is a high quality connection.
The YPbPr connection can be used for High Definition (HD) TV
signals. Next to the Y, Pb and Pr signals add the Audio Left and
Right signals for sound.
Match the YPbPr (green, blue, red) connector colours with the
cable plugs when you connect.
Use an Audio L/R cinch cable if your device also has sound.
Scart
SCART is a good quality connection.
The SCART connection can be used for CVBS and RGB video
signals but cannot be used for High Definition (HD) TV signals.
The SCART connection combines video and audio signals. The
SCART connection also supports NTSC playback.
Audio Out - Optical
Audio Out - Optical is a high quality sound connection.
This optical connection can carry 5.1 audio channels. If your
device, typically a Home Theatre System (HTS), has no HDMI
ARC connection, you can use this connection with the Audio In
- Optical connection on the HTS. The Audio Out - Optical
connection sends the sound from the TV to the HTS.
You can set the type of the audio out signal to fit the audio
capabilities of your Home Theatre System.
For more information, press
Keywords
and look up
Audio
Out Settings
.
If the sound does not match the video on screen, you can adjust
the audio to video synchronisation.
For more information, press
Keywords
and look up
Audio
to Video Sync
.
4.2
EasyLink HDMI CEC
EasyLink
With EasyLink you can operate a connected device with the TV
remote control. EasyLink uses HDMI CEC (Consumer
Electronics Control) to communicate with the connected
devices. Devices must support HDMI CEC and must be
connected with an HDMI connection.
EasyLink setup
The TV comes with EasyLink switched on. Make sure that all
HDMI CEC settings are properly set up on the connected
EasyLink devices. EasyLink might not work with devices from
other brands.
HDMI CEC on other brands
The HDMI CEC functionality has different names on different
12
To Next Page
Loading...
Need help?
General
Weight and Dimensions
