Philips AC0820/10 - Storage and Troubleshooting; Proper Appliance Storage; Troubleshooting Common Issues

8 EN
2 Pull the lter out from the appliance� Discard the used lter (g d)�
3 Remove all packaging materials of the new lter (g e)�
4 Put the lter into the appliance (g f)�
5 Reattach the base and rotate it clockwise to fasten the base (g g)�
6 Put the plug of the air purier in the power socket�
7 Press the power button to switch on the appliance�
8 Press and hold for 3 seconds to reset the lter lifetime counter�
9 Wash your hands thoroughly after replacing the lter�
Filter reset
You can replace the lter even before lter replacement alert ( ) displays on the screen�
After replacing a lter, you need to reset the lter lifetime counter manually�
1 Press the power button to turn on the appliance�
2 Within 10 seconds after power on, press and hold the mode switch button for
5 seconds to reset the lter lifetime counter�
6 Storage
1 Turn o the air purier and unplug from the power socket�
2 Clean the air purier, air quality sensor and the surface of the lter (see chapter
“Cleaning”)�
3 Let all parts air dry thoroughly before storing�
4 Wrap the lter in air tight plastic bags�
5 Store the air purier, lter in a cool, dry location�
6 Always thoroughly wash hands after handling a lter�
7 Troubleshooting
This chapter summarizes the most common problems you could encounter with the
appliance� If you are unable to solve the problem with the information below, contact the
Consumer Care Center in your country�
Problem Possible solution
The appliance does not
work even though it is
plugged in�
• The lter replacement alert is on but you have not replaced the
corresponding lter� As a result, the appliance is now locked� In
this case, replace the lter and reset the lter lifetime counter�