Philips AC0850/11 - Reset the Wi-Fi connection; Changing the mode setting

6 EN
Note:
•
This instruction is only valid when the air purier is being set up for the rst time. If the network has
changed or the setup needs to be performed again, see Chapter "Reset the Wi-Fi connection" on
page 6�
•
If you want to connect more than one air purier to your smartphone or tablet, you have to do this
one by one�
•
Make sure that the distance between your smartphone or tablet and the air purier is less than 10 m
without any obstructions�
Reset the Wi-Fi connection
Note:
•
Reset the Wi-Fi connection when your default network has changed�
1 Put the plug of the air purier in the power socket and press to turn on the air purier.
2 Press for 3 seconds until you hear a beep�
» The air purier goes to pairing mode.
» The Wi-Fi indicator blinks orange�
3 Follow the steps 3-4 in  section�
Connecting power
Note: Risk of electric shock! When you unplug the AC power cord, always
pull the plug from the socket� Never pull the cord�
Connect the power adapter to:
•
First, the power socket on the appliance�
•
Then, the wall outlet�

Note:
•
For optimum purication performance, close doors and windows.
1 Press the power button on the back of the air purier to switch on.
» The air purier operates in the auto mode by default.
2 Press the power button again to switch o the air purier.
Changing the mode setting
You can choose Auto mode, Turbo mode or the Sleep mode by pressing the mode switch button �
The brightness of air quality light reects the current running mode:
•
Sleep mode-lowest brightness
•
Auto mode-mid level brightness
•
Turbo mode-highest level brightness
Auto mode
In Auto mode, the appliance selects the fan speed in accordance with the
ambient air quality�
Turbo mode
In Turbo mode, the air purier operates on the highest speed.
Sleep mode
In Sleep mode, the air purier operates quietly at a low speed.