Note
• The child lock function is automatically
unlocked when the pre-filter cleaning
code or the filter replacement code
displays on the screen.
Switching the display
mode
The air purifier has dual display mode,
IAI display and PM2.5 display.
Note
• The air purifier operates in IAI display
mode by default.
• If the PM2.5 level is higher than 99,
"-- " will be displayed on the screen.
1 Touch for 3 seconds to switch to
PM2.5 display mode (Fig.r).
» The actual PM2.5 level displays
on the screen.
2 Touch for 3 seconds again to
switch back to IAI display mode
(Fig.s).
» The IAI level displays on the
screen.
Auto activating the night
sensing mode
When the air purifier operates in auto
mode or allergen mode, if the light
sensor detects the lights in your room
are turned off, the air purifier goes to
the night sensing mode automatically.
The air purifier will adjust the fan speed
in real-time to make sure the air in your
room is good. The air quality light will be
dimmed.
Note
• The light sensor detects the lights in
your room after 11 hours in the night
sensing mode.
• If the lights in your room are turned
on, the air purifier will quit the night
sensing mode and operate under the
previous mode. The air quality light
and the display will be on again.
• To exit the night sensing mode
manually, touch or button.
Setting the child lock
1 Touch and hold the child lock
button for 3 seconds to activate
child lock (Fig.p).
» The child lock icon displays
on the screen.
» When the child lock is on,
all the other buttons are not
responsive, only the child lock
icon blinks.
2 Touch and hold the child lock
button for 3 seconds again to
deactivate child lock (Fig.q).
» The child lock icon
disappears.
8 EN
To Next Page
Loading...
