7 Storage
1 Turn off the air purifier and unplug
from the wall outlet.
2 Clean the air purifier, air quality
sensor and pre-filter (see chapter
‘Cleaning’).
3 Let all parts dry thoroughly before
storing.
4 Wrap the filter and pre-filter
separately in air tight plastic bags.
5 Store the air purifier, the filter and
pre-filter in a cool, dry location.
6 Always thoroughly wash hands
after handling filters.e
Note
• This air purifier has no other user-
serviceable parts. For assistance,
contact the Consumer Care Center in
your country.
Filter reset
You can replace filters even if there is
no filter replacement code displayed on
the screen. After replacing a filter, you
need to reset the filter lifetime counter
manually.
1 Touch and simultaneously
for 3 seconds to enter the filter reset
mode (fig.}).
» Code (A3) of the NanoProtect
filter HEPA Series 3 displays on
the screen.
2 Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect filter HEPA
Series 3 (fig.|).
3 Code (C7) of the NanoProtect
Active Carbon filter displays on the
screen after the lifetime counter of
the NanoProtect filter HEPA Series 3
filter has been reset (fig.~).
4 Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect filter Active
Carbon and exit the filter reset
mode (fig.).
12 EN
To Next Page
Loading...
