Philips AC1217 - Getting started; Installing the filter

3 Getting started
Installing the lter
Note
• Make sure the air purier is
unplugged from the electrical outlet
before installing the lter.
• Make sure the side of the lter with
the tag is pointing towards you.
1 Pull the bottom part of the front
panel and then gently lift to remove
it from the air purier (g. c).
2 Press the clip down (1) and pull the
pre-lter towards you (2) (g. d).
3 Remove all lters (g. e).
4 Remove all packaging materials
from the lter (g. f).
5 Place the thick lter (FY1410) into
the air purier and then the thin AC
lter (FY1413) (g. g). The model
numbers are shown on each lter.
6 Attach the pre-lter back into the
air purier (g. h).
Note
• Make sure the side with the clip is
pointing towards you, and that all
hooks of the pre-lter are properly
attached to the purier.
7 Reattach the front panel by pressing
the top part of the panel onto the
top of the air purier (1). Then, gently
push the panel against the body of
the air purier (2) (g. i).
8 Wash your hands thoroughly after
installing lters.
2 Your air purifier
Congratulations on your purchase, and
welcome to Philips!
To fully benet from the support that
Philips oers, register your product at
www.philips.com/welcome.
Product overview
A Control panel
B Air quality light
C Air outlet
D Air quality sensor
E
NanoProtect lter Series 3
(FY1410)
F NanoProtect lter AC (FY1413)
G Pre-lter
H Air inlet
I Front panel
Controls overview
J On/O button
K Night sensing mode button
L Display screen
M Fan speed button
N Child lock button
5EN
English