Philips AC4012 - 7 Replace the filters; Replacing Activated Carbon and HEPA Filters

15
English
1 Switch off the purier and unplug it.
2 Place your ngers in the recesses of the
side panels and gently pull the bottom
part of the front panel towards you.
1
2
3 Lift the panel out of the hooks at the top
of the purier.
4 Remove all the lters from the purier.
7 Replace the
filters
The lter replacement light ( ) indicates the
lters have to be replaced.
Note
• If you remove the front panel for lter
changing while the purier is switched on, all
lights on the control panel will be off.
• Once the front panel is placed back to the
purier, all lights ash twice. Then, the purier
is off. Press the

button to switch on the
purier again.
Replace the activated carbon
lterandtheHEPAlter
Note
• The activated carbon lter and the HEPA lter
are not washable nor vacuum cleanable.
Replace both the activated carbon lter and
HEPA lter when the light goes on. This will
last for approximately 2 weeks.
On the last day of the 2 weeks, the purier
beeps every 30 minutes to inform you that the
lter needs to be replaced.
Tip
• When you remove or insert lters, place the
purier against a wall for more stability.
Note
• Insert the lters in the correct position.
• Make sure you place the lters in the order of
HEPA lter, activated carbon lter, and nally
the pre-lter.
• Make sure that the side with the tag is pointing
towards you.
EN
English