Philips AC4014 - Page 17

17
English
7 Place the pre-ler in the purier.
Note
•
Make sure that the side with the two
projections is pointing towards you, and that all
hooks of the pre-lter are properly attached
to the purier.
8 To reattach the front panel, insert the top
hooks into the top of the purier rst (1).
Then, push the panel against the body of
the purier (2).
1
2
9 Reset the activated carbon lter and the
HEPA lter lifetime (see ‘Reset the lter
lifetime counter’).
4 Remove all packaging material from the
new lters.
5 Place the new HEPA lter in the purier
rst.
6 Then, place the new activated carbon
lter in the purier.
EN
English