Philips AC4025/10 - Replace the Filters; Replace the Activated Carbon Filter and the HEPA Filter

13
EN
Note
•
Insert the lters in the correct position.
• Make sure you place the lters in the order of HEPA
lter and activated carbon lter.
• Make sure that the side with the tag is pointing
towards you, and the tag is at the bottom end of
the lter.
1 Switch off the purier and unplug it.
2 Place your ngers at the top panel and
gently pull the top part of the front panel
towards you (1). Lift the panel out of the
hooks at the bottom of the purier (2).
1
2
6 Replace the
filters
The lter replacement light ( ) indicate the
lter have to be replaced.
Replace the activated carbon
lterandtheHEPAlter
Note
•
The activated carbon lter and the HEPA lter are
neither washable nor vacuum cleanable.
Replace both the activated carbon lter and
HEPA lter when the
light starts to ash.
This will last for approximately 2 weeks.
When you do not replace the lter in time:
» The
lights up continuously.
In sleep mode, when the light starts to
ash but dim, replace both the activated
carbon lter and HEPA lter. This will last for
approximately 2 weeks.
When you do not replace the lter in time:
» The
lights up but dim continuously.
Tip
•
When you remove or insert lters, place the purier
against a wall for more stability.
EN
English