Philips AC6609 - Cleaning the Pre-Filter

16 EN
Cleaning the pre-filter
Filter alert light
status
Follow this
lights up on the
screen
Clean the pre-
filter
Note
• Filter light lights up
approximately once every two
weeks.
1 Rinse the pre-filters under a running
tap. If the pre-filters are very dirty,
use a vacuum cleaner or soft brush
to remove the dust before rinsing
under the tap.
Note
• Make sure to rinse the pre-filters
equipped in both sides of the
appliance.
2 Air dry the pre-filters.
Note
• Make sure that the pre-filters are
completely dry before you put them
back in the appliance. If they are still
wet, bacteria may multiply in them
and shorten the lifetime of the pre-
filters.
3 After the pre-filters are properly
put back in the appliance, reset
the filter lifetime counter. (Refer
to chapter 7 "Resetting the filter
lifetime counter".)