9EN
3 Getting started
Installing filters
Remove all packaging of the filters
before using the appliance. Unpack
them and place them into the appliance
described as follows:
Note
• There is one set of filters on each
side of the appliance. Each side is
equipped with one pre-filter and
two air purification filters.
• Make sure that you place the air
purification filters in the appliance
first and then the pre-filter.
• Make sure that the side with the tag
is pointing towards you.
1 Remove all packaging materials of
the air purification filters.
2 Pull the top part of the side panel to
remove it from the appliance.
3 Press the two clips down and pull
the pre-filter towards you.
4 Put the unpacked air purification
filters into the appliance.
Note
• Put the NanoProtect filter HEPA
Series 3 in the appliance first, and
then the NanoProtect filter AC.
To Next Page
Loading...
