Philips AE 3905 - Receiver Setup and Features; Included and Available Accessories; Powering the Device; Clock and Frequency Settings

ENGLISH
ACCESSORIES
Standard supplied
-In ear headphone
-SW-aerial SBC 3581
-2 batteries, type R03/UM4/AAA-cells
- Pouch
Available at your dealer
-AC/DC adapter, type SBC 3561
SUPPLY
Power adapter
• Connect a power adapter to the 3 V DC socket. The adapter must
supply 3 V DC 0 -G- 0 minuspole © to the 1.3 mm centre pin of the
3.4 mm socket. AC/DC adapter SBC 3561 is available at your dealer.
• To disconnect the set from the power completely, withdraw the
power plug from the wall socket.
Batteries
Insert as indicated two alkaline batteries, type R03, UM4 or AAA.
Remove the batteries if exhausted or if they are not to be used for a
long time. When the batteries are under load, the BATTERY indicator in
the display starts blinking. When the batteries are empty, the set will
switch itself off.
• Replace the batteries. During battery replacement, the clock- and
station-memory will be saved.
9/10 KHz -24/12 hours switch
With the 9/10 KHz switch you can select the size of the frequency
step between adjacent channels in the AM (=MW) band.
At the same time you select the 12- or 24 hours clocksystem:
-9 KHz corresponds with the 24 hours clock.
-10 KHz corresponds with the 12 hours clock.
In North- and South America it should be set to 10 KHz /12 hours clock.
In all other parts of the world to 9 KHz / 24 hours clock. In case of the
12 hours clock, the AM- or PM-indicator appears in the display.
5