Philips AJ 3040 - Philips AJ3040 Clock Radio Alarm Setup and Usage; Philips AJ3040 Clock Radio: How to Set Alarm Time; Philips AJ3040 Clock Radio: Alarm Activation and Deactivation; Philips AJ3040 Clock Radio Slumber Function Guide

Alarm
SETTING THE ALARM
Alarmtime
e Set the TIME SET switch @ to ALARM.
* Set the correct alarm time using the HOUR ©
and MINUTE ©) buttons.
e Set the TIME SET switch © to RUN.
ALARM ON
The clock radio can awaken you in two ways:
Wake by radio
e Make sure the volume of the radio is loud
enough to wake you.
e Set ALARM switch (2) to RADIO.
* You will be awakened at the set alarm time by
the radio.
Wake by buzzer
e Set ALARM switch (2) to BUZZER.
e At the set alarm time you will be awakened by
the buzzer.
ALARM OFF
You can switch off the alarm in two ways:
Switching off the alarm for nine minutes
e Press the SLUMBER OFF/REPEAT ALARM
button (6). With this switch you temporarily
switch off the alarm. After nine minutes the
alarm (radio or buzzer) will sound again. If you
press the SLUMBER OFF/REPEAT ALARM
button (6) again, the same will happen. If the
SLUMBER OFF/REPEAT ALARM button © is
not pressed again, the alarm will switch itself
off after 1 hour and 59 minutes. The following
day the alarm signal will sound again at the set
alarm time.
Switching off the alarm completely
e Set the ALARM switch @ to OFF. On the
display the ALARM indicator will disappear and
the alarm will be switched off. If you wish to be
awakened the following day again, you must
reset the ALARM switch to RADIO or BUZZER
before going to sleep.
Slumbering
SLUMBER
The clock radio has a built-in slumber function.
This function enables you to listen to the radio
before you fall asleep. You will not have to switch
off the clock radio yourself. This will take place
automatically.
English
SLUMBER ON
The time you listen to the radio before you fall
asleep is called the slumber time. The slumber
time is 59 minutes.
If you wish to slumber, carry out the following:
e Make sure the TIME SET switch @ is set to
RUN.
e Press the RADIO ON/SLUMBER button @
only. The display will show that you have a
slumbertime of 59 minutes.
SLUMBER OFF
You can switch off the radio before the slumber
time has elapsed:
e Press the SLUMBER OFF/REPEAT ALARM
button (6) and the clock radio is switched off.
— If the TIME SET switch @ is in position TIME or
ALARM, the slumber function will not work.
— The slumber function does not affect the alarm.
=- — — — — —-- — ——- +e — — —