Philips AJ3650 - Page 12

USING THE SENSOR TO DETECT OUTDOOR TEMPERATURE (See 3)
The main unit comes with an outdoor sensor. Using the sensor, the unit is capa-
ble to measure and display outdoor temperature through receiving data trasmit-
ted from the sensor placed at other location.
1. Place the sensor in a desired open area. The place must be within 50 meters
away from the main unit. Make sure the sensor is loaded with the batteries.
• For the first time using the outdoor sensor and the main unit, press
RESET located on the sensor back, and RESET located in the bottom of the
main unit. Then, the main unit will begin to receive transmission from the
sensor.
2. To update the outdoor temperature from the sensor any time, press and hold
AUTO SCAN for 5 seconds.
™ The temperature will be updated from the sensor about every 3 minutes.
™ When the outdoor temperature is updating with the sensor searching,
is displayed on the main unit.
To Improve the sensor reception
In case of intermittent/no connection,
• Slide the CHANNEL switch to Channel 2 or 3, located in the battery com-
partment of the sensor, then repeat the setup connection described above.
• Reduce the distance between the sensor and the main unit.
• Press and hold AUTO SCAN for about 3 seconds to start searchings for the
remote sensor signal.
Note:
– Each time you change a channel, press RESET both on the sensor and main
unit, and then press and hold AUTO SCAN on the main unit to search the
sensor.
AJ3650_12_EN 1/25/08 14:49 Page 12