EasyManua.ls Logo

Philips AQUA 8000 Series - Page 15

Philips AQUA 8000 Series
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
English
Problem Possible cause Solution
Too much water flows out
of the water tank at a too
high speed.
If too much water flows out
of the water tank at a too
high speed, the cap of the
tank is probably not closed
properly.
Check the cap and make sure it is fully
and properly closed.
The strip is not placed
properly in the bottom of the
water tank.
Check the strip and make sure that it is
fitted properly in the bottom plate of the
water tank.
You pushed the Aqua Boost
pedal too often.
Push the Aqua Boost pedal (Fig. 4) only
once each time and check after each
time if you have achieved the wetness
level you want.
The floor dries with stripes
when I use the water tank.
You added too much liquid
cleaner to the water.
Use only a few drops of liquid cleaner or
use a cleaner that foams less.

Table of Contents

Related product manuals