Philips AUT3234 - Product Specifications; Product Introduction

I. Product Introduction
Congratulations on your purchase and welcome to Philips! Our under-the-sink
water filtration system AUT3234 comes with a 4-stage ultrafiltration, which
eectively reduces particles, heavy metals, volatile organic compounds, pesticides,
bacteria, and pollutants down to 0.01 micron*, while retaining beneficial minerals
at the same time.
Read this user manual carefully before you use the appliance. Save it for future
reference.
* The substances removed or reduced by this system are not necessarily in all
user’s water.
** When the inlet water pressure exceeds 0.4 MPa, a pressure relief valve should
be installed before the system. When the inlet water pressure is below 0.1 MPa,
a pressure booster should be installed before the system. The pressure relief valve
and extra pressure booster need to be purchased separately.
Product name Philips under-the-sink water filtration system
AUT3234
2 liters/minute
CBPA filter: 4000 liters
UF filter: 8000 liters
CB filter: 4000 liters
Product model
Water flow rate
Filtration capacity
Inlet water pressure 0.1-0.4 MPa**
Inlet water temperature
5℃-38℃
Applicable water source
Municipal tap water, which meets all European
Directive on Water for Human Consumption 98/83
requirements and its national transpositions in
the various EU member states.
II. Product Specification
Rated voltage
1
4.5V