Philips Avalon FM50 - Connecting a Transducer to the Monitor

3 Basic Operation
40
Connecting a Transducer to the Monitor
You can plug a fetal transducer, a ECG/IUP patient module, an Avalon CTS Cordless Fetal
Transducer System interface cable (M2731-60001, red connector), or an external event marker into any
of the four fetal sensor sockets marked or "Fetal Sensors" (depending on geography). For
measuring maternal SpO
2
, connect the sensor to the socket marked or "SpO
2
" (depending on
geography), and for maternal non-invasive blood pressure, connect the cuff to the socket marked
or "NBP" (depending on geography).
For the FM40 and FM50, you can connect an Avalon CTS Cordless Fetal Transducer System interface
cable (M2732-60001, black connector) to one of the two dedicated black sockets marked "Tele" at the
rear of the monitor, as an alternative to using one of the fetal sensor sockets at the front.
1 SpO
2
socket
2 Noninvasive blood pressure
socket
3 Fetal sensor sockets
1 M2732-60001 interface cable to
Avalon CTS Cordless Fetal
Transducer System.
2 Connect the black connector to
one of the two black sockets
(marked "Tele") on the rear of
the monitor.