EasyManua.ls Logo

Philips AVENT SCD501 - Frequently Asked Questions

Philips AVENT SCD501
42 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Why does the parent unit beep?
Iftheparentunitbeepswhilethe‘link’light
ashesredcontinuously,theconnectionwith
thebabyunitislost.Movetheparentunitcloser
tothebabyunitorturnonthebabyunitifit
wasoff.Thebabyunitmaybeturnedoff.Turn
onthebabyunit.
Why does the appliance produce a high-pitched
noise?
Theunitsmaybetooclosetoeachother.
Makesuretheparentunitandthebabyunitare
atleast1meter/3.5feetawayfromeachother.
Why don’t I hear a sound/Why can’t I hear
my baby cry?
Thebabyunitandtheparentunitmaybeout
ofrangeofeachother.Reducethedistance
betweentheunits.
Youmayhavesetthevolumetothelowest
level(mute).Increasethevolume.
Why does the parent unit react too quickly to
other sounds?
Thebabyunitalsopicksupothersoundsthan
thoseofyourbaby.Movethebabyunitcloser
tothebaby(butobservetheminimumdistance
of1meter/3.5feet).
The specied operating range of the baby 
monitor is 300 meters/985 feet. Why does my
baby monitor manage a much smaller distance
than that?
Thespeciedrangeisonlyvalidoutdoorsin
openair.Insideyourhouse,theoperatingrange
islimitedbythenumberandtypeofwallsand/
orceilingsinbetween.Insidethehouse,the
operatingrangeisupto50meters/150feet.
13 Recycling
Thissymbolmeansthatyoumustnot
throwawaytheappliancewiththenormal
householdwaste.Disposeoftheappliance
atanofcialcollectionpointforelectrical
appliances.Correctdisposalhelpstopreserve
theenvironment.
14 Frequently asked
questions
Why don’t the power-on light of the baby unit
and the ‘link’ light of the parent unit come on
when I press the on/off buttons of the units?
Perhapsoneorbothunitsarenotpluggedin
properly.Connecttheunitstoanelectrical
outletandpresstheon/offbuttonsonboth
unitsfor3secondstoestablishconnection
betweentheparentunitandthebabyunit.
Ifyouusetheparentunitonbatteries,the
batteriesoftheparentunitareemptyorthere
arenobatteriesinthebatterycompartment.
Why does the ‘link’ light on the parent unit ash 
red continuously?
Thebabyunitandtheparentunitareout
ofrangeofeachother.Movetheparentunit
closertothebabyunit.
Thebabyunitmaybeturnedoff.Turnonthe
babyunit.