Philips AVENT SCD501 - Prepare Parent Unit; Parent Unit - Inserting Batteries

6
1 Pressthereleasebutton(1)tounlockthebattery
compartmentlidandremovethelid(2).
2  Insertthenon-rechargeablebatteriesorfully
chargedrechargeablebatteries.
D Note:
Makesurethe+and-polesofthebatteries
pointintherightdirection.
3  Toreattachthebatterycompartmentlid,rst
insertthelugsintothebottomrimofthe
batterycompartment.Thenpushthelidhome
untilitlocksintoplacewithaclick.
6.2 Parent unit
Theparentunitrunsonelectricalpower.
Youcanalsoinsertbatteriestoallowmobileuse
oftheparentunit.
6.2.1 Operation on electrical power
1  Putthesmallpluginthesocketintheside
paneloftheparentunitandputtheadapter
in an electrical outlet.
6.2.2 Inserting the batteries
Iftheparentunitisnotclosetoanelectrical
outlet,youcanrunitontwo1.5VR6AAalkaline
non-rechargeablebatteriesortwo1.2VR6
AArechargeablebatteries(notsupplied).The
operatingtimeonfullbatteriesisupto24hours,
dependingonthetypeofbatteriesusedandon
howlongandhowoftenyouusetheparentunit
onbatteries.
D Note:
Pleasenotethattheparentunitdoesnotcharge
thebatterieswhenitisconnectedtoanelectrical
outlet.Youcanuserechargeablebatteriesinthe
parentunit,butyouneedtochargethemina
separatecharger.
B Warning:
Unplug the parent unit and make sure your
hands and the unit are dry when you insert the
batteries.