Feeding breast milk with the bottle
For your child’s safety and health
WARNING!
- Continuous and prolonged sucking of uids will cause tooth decay.
- Always check food temperature before feeding.
- Throw away at the rst signs of damage or weakness.
- Keep components not in use out of the reach of children.
- Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
- Never use feeding teats as a soother.
- Always use this product with adult supervision.
- Keep the bottle cap away from children to avoid suocation.
- Do not allow children to play with small parts or walk/run while using bottles.
- Inspect all parts before use and pull the feeding teat in all directions. Throw away any part at the rst signs of damage or weakness.
- Always discard any breast milk that is left over at the end of a feed.
Caution: To avoid damage to the bottle
- Do not place in a heated oven, plastic can melt.
- Plastic material properties may be aected by disinfection and high temperatures. This can aect the t of the bottle cap.
- Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant for longer than recommended because this may
damage the product.
Before using the bottle
- Inspect the bottle and feeding teat before each use and pull the feeding teat in all directions to prevent a choking hazard.
Throw away at the rst signs of damage or weakness.
- Clean and disinfect the bottle before rst use and after every use (see ‚Cleaning and disinfecting‘).
Assembling the bottle
1. The teat is easier to assemble
if you move it back-and-forth
while pulling it upwards instead
of pulling it up in a straight line.
2. Make sure you pull the teat
through until its lower part is
aligned with the screw ring.
3. Make sure you place the
cap vertically onto the bottle
so that the teat sits upright.
4. Screw the screw ring with
teat and cap on the bottle.
5. To remove the cap, place your
hand over the cap and your
thumb in the dent of the cap.
To Next Page
Loading...
