EasyManua.ls Logo

Philips AZ 2048 - Trouble Shooting

Philips AZ 2048
35 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 -5
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Under no circumstances should you try to repair the set yourself, as this will invalidate the
guarantee.
Problem
•Solution
Remote control does not function properly
–Batteries exhausted/ incorrectly inserted
Insert (fresh) batteries correctly
–Distance/ angle between the set too large
•Reduce the distance/ angle
No sound /power
–Volume not adjusted
•Adjust the VOLUME
–Mains lead not securely connected
•Connect the AC mains lead properly
–Batteries exhausted/ incorrectly inserted
Insert (fresh) batteries correctly
–Headphones connected to the set
•Disconnect headphones
–Electrostatic discharge/interference
•Unplug the set. If batteries inserted, remove
batteries from the battery compartment. Press and
hold STANDBY
y
on the set for 10 seconds, then
re-plug / replace battery supply, and try activating
the set again
Severe radio hum or noise
Electrical interference: set too close to TV, VCR or
computer
•Increase the distance
Poor radio reception
–Weak radio signal
•FM: Adjust the FM telescopic aerial
/indication
–No CD inserted
Insert a suitable disc
CD badly scratched or dirty
•Replace/ clean CD, see Maintenance
Laser lens steamed up
•Wait until lens has cleared
indication
–CD-R(W) is blank/ not finalized
•Use a finalized CD-R(W)
The CD skips tracks
CD damaged or dirty
•Replace or clean CD
SHUFFLE or PROGRAM is active
Switch off SHUFFLE / PROGRAM
Sound skips during MP3 playback
–MP3 file made at compression level exceeding
320 kbps.
•Use a lower compression level to record CD tracks
into MP3 format.
–Disc damaged or dirty.
•Replace or clean disc.
Cannot play/ find desired MP3 titles
–Wrong file extension used and/ or filename
unsuitable text characters used.
•Make sure the file names are typed in English text
characters and that the MP3 files end with .mp3
TROUBLE SHOOTING

Related product manuals