AVIS
AVI SO
AUX (audio cable not included) .(See 9)
This 3.5mm socket allows you to connect other audio
equipment to your system.
1. Press
y
to on, then the source selector to select
AUX.
= Display shows: AUX and PHILIPS scrolls
2. Use an audio cable to connect the AUX socket to
the LINE OUT/headphone socket on your external
equipment.
3. To avoid noise distortion, turn down the volume on
your external equipment.
4. To adjust the sound and volume, use the sound
controls on your external equipment and the
AZ3068.
Cassette recorder
Cassette playback
1. Press
y
to on, then the source selector to
select TAPE.
= Display shows throughout tape
operation.
2. Insert a cassette and close the door.
3. Press PLAY 1 to start playback.
4. To pause, press PAUSE ;;. Press PAUSE ; again
to resume.
5. Press SEARCH 5/6 to fast wind the tape.
6. To stop the tape, press STOP
•
OPEN 9/.
Helpful Hints:
- During playback, the keys are automatically
released at the end of a tape and the set is
switched off (unless PAUSE mode
;
has been
activated.)
- During fast forwarding/rewinding, the keys will
not be released at the end of a tape. To switch
off the set, make sure the cassette keys are
also released.
GENERAL INFORMATION ON RECORDING
• Recording is permissible insofar as copyright or.
other rights of third parties are not infringed.
• For recording, use only NORMAL type cassettes
(IEC type I) on which the tabs have not yet been
broken. This deck is not suited for recording on
CHROME (IEC II) or METAL (IEC IV) type cassettes.
• The best recording level is set automatically.
Altering the VOLUME or BASS controls will not
affect the recording.
• To protect a tape from accidental erasure, break
out the tabs. If you wish to record again, cover the
tabs with a piece of adhesive tape.
CD Synchro Start recording
1 Select CD function.
2 Insert a CD and if desired, programme track
numbers.
3 Open the cassette door.
4 Insert a suitable tape into the cassette deck and
close the door.
5 Press RECORD 0 to start recording.
™ Playing of the CD/program starts automatically
from the beginning. You don’t need to start the
CD player separately.
• To select and record a particular passage within
a CD track:
– Press ∞ or §. Release the control when you
recognize the passage you want.
– To pause CD playback, press 2;.
™ Recording starts from this exact point in the
track when you press RECORD 0.
6 To pause recording, press PAUSE ;.
Press PAUSE ; again to resume recording.
7 To stop recording, press STOP/OPEN 9/.
Recording from the Radio
1 Tune to the desired radio station (see Tuning to
radio stations).
2 Follow steps 3-7, under CD Synchro Start record-
ing.
AUX / CASSETTE RECORDER CASSETTE RECORDER
To Next Page
Loading...
