Philips BiPAP A40 - 5.3 Accessing the Standby Screen; 5.4 Accessing the Setup Screen

BiPAP A40 user manual
40
5.3 Accessing the Standby Screen
1. After you press the button, the Startup screen appears momentarily, indicating the device
name and software version.
2. The Standby screen then appears, shown here.
It displays the date and time, therapy mode, a
patient accessory panel (if a patient accessory is
attached), a status panel, and the soft key panel.
3. You can perform the following actions from the
Standby screen :
a. If a humidier is connected, you can activate
the humidier preheat function by pressing
the Left (Preheat) key. See the Accessories
chapter for more information.
b. If an accessory module is attached, you can monitor the connection to any attached
patient accessory.
c. Access the menu by selecting the Up (Menu) key.
d. Initiate therapy by selecting the Right (Therapy) key. Selecting this key starts the airow
and displays the Monitoring screen.
5.4 Accessing the Setup Screen
1. There are two ways to access the Setup screen:
- Select Menu from the Standby screen
- Perform the Provider Menu Access Key
Sequence from the Standby screen
2. You can access the device and therapy settings from
this screen. The menu options vary based on your
device setup. A sample screen is shown here.