Philips BT2200 - Get Started; Charge the Built-in Battery; Switch On;Off

5
English
EN
3 Get started
Always follow the instructions in
this chapter in sequence.
Charge the built-in battery
The speaker is powered by a built-
in rechargeable battery.
Note
• Before use, fully charge the built-in battery.
• The micro USB socket is for charging only.
• Rechargeable battery has a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
1 Pull open the protective cover.
2 Connect the USB cable between
• the USB charging socket on the speaker,
and
• a USB socket on a computer.
The LED indicator on the button
indicates the battery status.
DC IN
LED indicator on
the button
Battery status
Solid red Under
charging
Off, or solid white when the
speaker is switched on
Fully charged
Flashing red Low power
Switch on/off
• Press and hold to switch the speaker on.
» The LED indicator on the button
turns solid white.
» Forrst-timesetup,theLEDindicator
on the buttonasheswhite,
indicating that the speaker is in pairing
mode.
• To switch off, press and hold again.
» The LED indicator on the button
turns off.
100%