Philips BT2200 - Use Bluetooth Devices; Connect a Device

7
English
EN
4 Use Bluetooth
devices
With this speaker, you can listen to audio
from Bluetooth-enabled devices and control
the incoming call through Bluetooth.
Connect a device
Note
• Make sure that your Bluetooth device is compatible
with this speaker.
• Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
• The speaker can memorize a maximum of 8 paired
devices.
• Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
• Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
• Keep away from any other electronic device that may
cause interference.
• The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
Philips BT2200
1 Make sure that the speaker is in pairing
mode, that is, the LED indicator on the
buttonasheswhite.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
(refer to the user manual of the device).
3 When [Philips BT2200] is displayed on
your device, select it to start pairing and
connection. If necessary, enter default
password “0000”.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator on the button turns solid
white.
To disconnect the Bluetooth-enabled device:
• Disable Bluetooth on your device;
• Press on the speaker; or
• Move the device beyond the
communication range.
To clear the existing pairing information:
• Press and hold for more than 10
seconds.
To reconnect the Bluetooth-enabled device:
• For a paired Bluetooth device on which
automatic reconnection is enabled, this
product reconnects with it once it is
detected.
• For a paired Bluetooth device that does
not support automatic reconnection,
reconnect it with this product manually.
To connect another Bluetooth-enabled device:
• Disable Bluetooth on the current device,
and wait for around 3 minutes before you
connect another device.
LED indicator on
the button
Description
Flashing white Connecting or waiting
for connection
Solid white Connected