Philips CD 720 - Searching the Loudest Passage (Peak Search); Setting the Fade-In and Fade-Out Time (Fader); Scanning a CD (Scan); Adjusting the Sound Level (Volume +)

English
PLAYBACK
SEARCHING THE LOUDEST PASSAGE
( P E AK SEARCH)
• In STOP mode, press
- PEAK starts flashing
and the CD or the
programme will now
be scanned for the
loudest passage (the peak).
- The display shows the track being scanned and
its elapsed playing time.
- When the loudest
passage has been
found it will be
repeated continuous¬
ly (from 2 seconds before the peak until 2 sec¬
onds after the peak)
• You can now adjust your recording device.
• You can stop the search by pressing STOP/CP
5 or OPEN/CLOSE 7; if you press
PLAY/REPLAY 6, the CD or the programme will
be played from the beginning.
NOTE!
The following functions can only be operated
using the remote control (CD720 only).
SCANNING A CD (SCAN) _
• Press SCAN 16 before or during play.
- If the CD compartment was open, it will now
close.
- SCAN lights up for
2 seconds and the
first 10 seconds of
each track are played
in turn; 10 seconds are counted down each
time under REM TRACK TIME.
• When the player reaches a track which you
wish to hear in full, press SCAN again or
PLAY/REPLAY 6.
ADJUSTING THE SOUND LEVEL (- VOLUME +)
PEAK SEARCH 9.
rrj —
8 y ‘>*
0:8
l O zt { l
1C IZ : I (
o
revj rues rm.
n n o
u: u o
SETTING THE FADE- IN AND FADE-OUT
TIME (FADER) _
• During play press FADER 9.
- The sound level will now gradually decrease
(FADE OUT), after which the player will go into
the PAUSE mode.
FPHEE F Pi HE z
F H HE _
Press FADER again. .
Play continues and the sound level will increase
again to the originally set level (FADE IN).
h F! JjL ~
FPHE z FPHEE
NOTE!
Use the - VOLUME + keys only if the player is
connected to an amplifier or HiFi system with¬
out its own remote control.
The setting chosen with - VOLUME + will be
cancelled when the player is switched off.
- VOL lights up; the output signal from the player
VEIL EE
V LI L z z
'WL E.
VOLE
•JIJLz
UDL _
• Release the key as soon as the required sound
level is obtained.
• Hold VOLUME + 17 pressed down.
- VOL lights up; the output signal will now
increase again gradually to the maximum level
- The successive steps are shown on the display.
u n i
M U l _
'JOLz
•JOL E
uni r
M U l _
ii rn r „
m u *- z z
u ni r c
M U /_
• Release the key as soon as the required sound
level is obtained.
10