Philips CM8802 - Page 5

Adjustment
D
( -'" , | ( D
Switching on/off
Switching on 0
• Press button © (LED lights up).
Switching off 0
• Press button © again.
Input I/n switch
• With the INPUT I/n switch you can
either choose the signal from the phono
connectors or from the EURO/DIN
connectors.
B
o
o •
GREEN
Green switch
• With button o°. you can switch to
green letters (used with text
processing).
V.Height CD
• You can adjust the image height with
knob CD.
V.Centering 0
• The image may be positioned
vertically with knob 0.
H.Width E3
• The image width can be adjusted with
knob ED.
El
STATUS
RGB
RGB STATUS switch
Push the RGB STATUS switch when
your RGB computer does not supply
the RGB STATUS voltage. When doing
so the Euroconnector and DIN
connector will be in the RGB mode.
ET
VCR
VCR button
• If you use your monitor as display for
your Video Recorder or VLP press
button ‘VCR’ to adjust the picture.
In case a TV Tuner is connected this
button should be released.
Picture and sound controls
For an optimum adjustment of the video
and audio input signals various controls
are available.
General
• The image may be positioned
horizontally with knob CD.
• Adjust brightness with knob -$•.
• Adjust contrast with knob 3.
• Adjust saturation of colour with
knob © (not with connected RGB
sources).
• Adjust volume with knob ^d.
• If the picture is not as desired, check
whether all controls are in the correct
position.
• The rear panel should only be
removed by a service technician.
• If necessary, clean with a damp
sponge. Do not use alcohol, spirits or
ammonia.
3