Philips css2133b - Wall Mounting Guide; Product Technical Specifications

11EN
5 Wall mount
Note
• Before wall mounting, make sure the wall can support
the weight of this product.
• For wall mounting, this product must be securely
attached to the wall in accordance with the installation
instructions. Improper wall mounting may result in
accident, injury or damage. If you have any query,
contact Consumer Care in your country.
• Before wall mount, you need not remove the two
rubber feet at the bottom of this product, otherwise
the rubber feet cannot be xed back.
Screw length/diameter
Depending on the type of wall mounting this
product, make sure that you use screws of a
suitable length and diameter.
See the illustration in the quick start guide on
how to wall mount this product.
1) Drill two holes on the wall.
2) Secure the dowels and screws in the holes.
3) Hang this product on the fastening screws.
> 25mm
3-4mm
4m
m
6 Product
specifications
Note
• Specications and design are subject to change without
notice.
Amplier
• RMS total output power:
60W (+/- 0.5 dB, 30% THD)
• Frequency response: 20 Hz-20 kHz / ±3 dB
• Signal-to-noise ratio:
> 65 dB (CCIR) / (A-weighted)
• Input sensitivity:
• AUX: 600 mV
• AUDIO IN: 250 mV
Audio
• S/PDIF Digital audio input:
• Coaxial: IEC 60958-3
• Optical: TOSLINK
Bluetooth
• Bluetooth proles: A2DP
• Bluetooth version: 3.0 + EDR
Main unit
• Power supply: 110-240 V~, 50-60 Hz
• Power consumption: 20 W
• Standby power consumption: ≤ 0.5 W
• Speaker impedance: 4 ohm woofer, 4 ohm
tweeter
• Speaker drivers: 25 x 120 mm (1 x 5")
woofer, 38 mm (1.5") tweeter
• Frequency response: 150 Hz-20 kHz
• Dimensions (W x H x D):
708 x 47 x 65 mm
• Weight: 1.1 kg