Philips CX5120 - Using the Heater; Wi-Fi Connection Setup

6 EN
3 Using the Heater
Wi-Ficonnection
SettinguptheWi-Ficonnectionforthersttime
1 Download and install the Philips “Air+” app from the App Store or
Google Play�
2 Put the plug of the Heater in the power socket and touch to
turn on the Heater.
» The Wi-Fi indicator blinks for the rst time.
3 Make sure that your smartphone or tablet is successfully connected to your
Wi-Fi network.
4 Launch the “Air+” app and click on “Connect a New Device” or press the “+”
button on the top of the screen. Follow the onscreen instructions to connect
the Heater to your network.
Note:
•
This instruction is only valid when the Heater is being set up for the rst time.
If the network has changed or the setup needs to be performed again, see
Chapter “Reset the Wi-Fi connection” on page 6�
•
If you want to connect more than one Heater to your smartphone or tablet, you
have to do this one by one.
•
Make sure that the distance between your smartphone or tablet and the Heater
is less than 10 m without any obstructions.
ResettheWi-Ficonnection
Note:
•
Reset the Wi-Fi connection when your default network has changed.
1 Put the plug of the Heater in the power socket and touch to turn on the
Heater.
2 Touch and hold for 3 seconds until you hear a beep.
» The Heater goes to pairing mode.
» The Wi-Fi indicator blinks.
3 Follow the steps 3-4 in “SettinguptheWi-Ficonnectionforthersttime”
section.