Philips D141 - Page 29

27EN
Note
• The remote access PIN code is the same as
your system PIN. The preset PIN is 0000.
Activate/deactivate the remote
access
You can allow or block remote access
to the answering machine.
1
Press / or MENU/OK > [ANSW
MACHINE] > MENU/OK.
2
Select [REMOTE ACC.], then press
MENU/OK to conrm.
3
Select [ACTIVATE]/[DEACTIVATE],
then press MENU/OK to conrm.
» The setting is saved.
Change the PIN/passcode
1
Press / or MENU/OK > [ANSW
MACHINE] > MENU/OK.
2
Select [REMOTE ACC.] > [CHANGE
PIN], then press MENU/OK to
conrm.
3
Enter the old PIN/passcode, then
press MENU/OK to conrm.
4
Enter the new PIN/passcode, then
press MENU/OK to conrm.
5
Enter the new PIN/passcode again,
then press MENU/OK to conrm.
» The setting is saved.
Access the answering machine
remotely
1
Make a call to your home number
with a touch tone phone.
2
Enter # when you hear the
announcement.
3
Enter your PIN code.
» You now have access to your
answering machine, and you
can listen to the new messages.
Note
• You have 2 chances to enter the correct PIN
code before your phone hangs up.
4
Press a key to carry out a function.
See the Remote access commands
table below for a list of available
functions.
Note
• When there is no message, the phone hangs
up automatically if no key is pressed for 8
seconds.
• When the answering machine is turned o
but the remote access function is activated,
the answering machine will still pick up the
call in [ANSWER ONLY] mode after 10 rings.