15
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
1 Press SLEEP repeatedly to select a set
period of time (in minutes).
When the sleep timer is activated, the »
display shows
, and the volume will
gradually decrease in the last 5 minutes.
To deactivate sleep timer
1 Press SLEEP repeatedly until [OFF] (off)
is displayed.
When the sleep timer is deactivated, »
disappears on the display.
Adjust display brightness
1
Press BRIGHTNESS/REP ALM
repeatedly to select different levels of
display brightness.
Activate and deactivate the alarm
timer
1 Press ALM 1 or ALM 2 repeatedly to
activate or deactivate the timer.
If the timer is activated, [ »
AL 1] or
[
AL2] is displayed.
If the timer is deactivated, [ »
AL1] or
[
AL2] disappears.
Repeat alarm
1 When the alarm rings, press
BRIGHTNESS/REP ALM.
The alarm repeats ringing minutes later. »
Tip
You can press • / to adjust the interval to
repeat alarm.
Stop alarm ring
1 When the alarm rings, press the
corresponding ALM 1 or ALM 2.
The alarm stops but the alarm settings »
remain.
View the alarm settings
1 Press ALM 1 or ALM 2.
EN
To Next Page
Loading...
