Philips DC315/37 - Setting Time and Date; Powering On and Off

Set time and date
1 In standby mode, press and hold TIME SET/AUTO SCAN for 2
seconds.
The hour digits are displayed and begin to blink. »
2 Press TUNING +/- to set the hour.
3 Press TIME SET/AUTO SCAN to conrm.
The minute digits are displayed and begin to blink. »
4 Repeat steps 2-3 to set the minute, year, month, day and 12/24 hour
format.
Turn on
1 Press POWER.
The unit switches to the last selected source. »
Switch to standby
1 Press POWER again to switch the unit to standby mode.
The time and date (if set) appear on the display panel. »
Tip
After being idled for 15 minutes in standby mode, the screen turns •
dim automatically.
To light up the screen, press any button.
•
Adjust volume
1 During play, press VOL +/- to increase/decrease the volume.