Philips DCB293 - Turn on; Switch to Standby; 4 Play; Play a Disc

12
4 Play
Play a disc
1
Press CD to select the disc source.
2 Press to open the disc compartment.
3 Insert a disc with the printed side facing
outward.
4 Press to close the disc compartment.
Play starts automatically. If not, press »
.
Play from USB
Note
Ensure that the USB device contains playable 
audio content.
1 Insert the USB device into the socket.
2 Press USB to select the USB source.
Play starts automatically. If not, press »
.
To select a folder, press 
/ .
7RVHOHFWDQDXGLRÀOHSUHVV
/ .
5 Press PROG/CLOCK SETWRFRQÀUP
The hour digits are displayed and begin »
to blink.
6 Press / to set the hour.
7 Press PROG/CLOCK SETWRFRQÀUP
The minute digits are displayed and »
begin to blink.
8 Press / to set the minute.
9 Press PROG/CLOCK SETWRFRQÀUPWKH
clock setting.
Turn on
1
Press .
The unit switches to the last selected »
source.
Switch to standby
1 Press again to switch the unit to
standby mode.
The clock (if set) appears on the »
display panel.
To switch the unit to Eco Power Standby
mode:
1 Press and hold for more than 2
seconds.
The backlight on the display panel »
turns off.
Tip
The unit switches to Eco Power Standby mode 
after 15 minutes in standby mode.
To switch between standby mode and Eco
Standby Mode:
1 Press and hold for more than 2
seconds.
EN