Philips DCB293 - Play from an External Device; Listen through Headphone; 8 Product Information

19
8 Product
information
Note
Product information is subject to change 
without prior notice.
6SHFLÀFDWLRQV
$PSOLÀHU
Total output power 2 x 10 W RMS
Frequency
response 80 Hz - 16 kHz, ± 3 dB
Signal to noise ratio > 60 dB
MP3 link input 0.5 V RMS 20 k
Disc
Laser type Semiconductor
Disc diameter 12 cm /8 cm
Support disc CD-DA, CD-R,
CD-RW, MP3-CD,
WMA-CD
Audio DAC 24 Bits / 44.1 kHz
Total harmonic
distortion < 1.5%
Frequency
response 60 Hz -16 kHz (44.1 kHz)
Signal to noise ratio > 55 dBA
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
1 When the unit is turned on, press
SLEEP/TIMER repeatedly to select a set
period of time (in minutes).
When sleep timer is activated, »
is
displayed.
To deactivate sleep timer
1 Press SLEEP/TIMER repeatedly until
[OFF] (off) is displayed.
When sleep timer is deactivated, »
disappears on the display.
Play from an external device
You can also listen to an external audio device
through this unit.
1 Press USB/MP3 LINK to select the MP3
link source.
2 Connect the supplied MP3 link cable to:
the  MP3 LINK jack (3.5mm) on the
unit.
the headphone jack on an external 
device.
3 Start to play the device (see the device
user manual).
Listen through headphone
1
Plug a headphone into the socket on
the unit.
English
EN