Philips DTB297 - Other System Features; Alarm Management; Sleep Timer and Brightness Control

14 EN
6 Other features
Adjust volume level
1 During play, press VOL +/- to increase/
decrease the volume level.
Set the alarm timer
You can set two alarms which go off at different
time.
1 Make sure that you have set the clock
correctly (see ‘Set time and date’ on page
9).
2 Press and hold ALARM 1 or ALARM 2 for
2 seconds.
» The unit beeps.
» [SET AL] (set alarm), or , and the
hour digits start to blink.
3 Press TUNING +/- / to set the hour,
then press OK/ toconrm.
» The minute digits start to blink.
4 Repeat step 3 to set the minute, alarm
date (work day, daily, or weekend), source
(DOCK, BUZZ, DAB, or TUNER), and
volume.
» Afterconrmationofthevolume
setting, the unit beeps once again.
Activate and deactivate the alarm
timer
1 Press ALM 1 or ALM 2 repeatedly to
activate or deactivate the timer.
» If the timer is activated, or is
displayed.
» If the timer is deactivated, or
disappears.
Repeat alarm
• When the alarm rings, press
BRIGHTNESS/REP ALM.
» The alarm repeats ringing in several
minutes.
Stop alarm ringing
• When the alarm rings, press the
corresponding ALARM 1 or ALM 2
button.
» The alarm stops but the alarm settings
remain.
View the alarm settings
• Press ALARM 1 or ALM 2.
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
• Press SLEEP repeatedly to select a set
period of time (in minutes).
» When the sleep timer is activated, the
display shows , and the volume will
gradually decrease in the last 5 minutes.
To deactivate sleep timer
• Press SLEEP repeatedly until [OFF] (off) is
displayed.
» When the sleep timer is deactivated,
disappears on the display.
Adjust display brightness
• Press BRIGHTNESS/REP ALM repeatedly
to select different levels of display
brightness.