Philips DTM3170 - Listen to the radio; Tune to a radio station; Program radio stations; Program radio stations automatically

13EN
6 Listen to the
radio
Tune to a radio station
Tip
• For optimal FM reception, fully extend and adjust the
position of the FM antenna.
1 Press CD/FM repeatedly to select the
tuner source.
2 Press and hold / for more than two
seconds.
» [SEARCH] (search) is displayed.
» The radio tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more stations.
• To tune to a weak station, press /
repeatedly until you nd optimal
reception.
Program radio stations
Tip
• You can program a maximum of 20 preset radio
stations.
Program radio stations automatically
In tuner mode, press and hold PROG for
more than two seconds to activate automatic
program mode.
» [AUTO](auto) is displayed.
» All available stations are programmed
in the order of waveband reception
strength.
» The rst programmed radio station is
broadcast automatically.
Program radio stations manually
1 Tune to a radio station.
2 Press PROG to activate program mode.
» [PROG] (program) blinks on the
display.
3 Press / to allocate a number (1 to 20)
to this radio station, and then press PROG
to conrm.
» The preset number and the frequency
of the preset station are displayed.
4 Repeat the above steps to program other
stations.
Note
• To overwrite a programmed station, store another
station in its place.
Select a preset radio station
In tuner mode, press / to select a preset
number.
Display play information
RDS (Radio Data System) is a service
that allows FM stations to show additional
information. If you tune to an RDS station, an
RDS icon and the station name are displayed.
1 Tune to an RDS station.
2 Press RDS/DISPLAY repeatedly to scroll
through the following information (if
available):
» Station name
» Program type such as [NEWS] (news),
[SPORT] (sport), [POP M] (pop
music)...
» RDS RT Frequency