Philips DTM3170 - Adjust sound; Adjust volume; Select a preset sound effect; Mute sound

14 EN
7 Adjust sound
Adjust volume
During play, press VOL +/- to increase/decrease
the volume.
Select a preset sound effect
During play, press SOUND repeatedly to select:
• [BALANCED] (balanced)
• [CLEAR] (clear)
• [POWERFUL] (powerful)
• [WARM] (WARM)
• [BRIGHT] (bright)
Mute sound
During play, press to mute or restore sound.
Adjust display brightness
Note
• You can adjust the display brightness in standby mode
only.
In standby mode, press RDS/DISPLAY
repeatedly to adjust display brightness.
• Full brightness (100%)
• Half brightness (70%)
• Brightness low (40%)
8 Other features
Set the sleep timer
This docking system can switch to standby
automatically after a set period of time.
1 When the unit is turned on, press SLEEP/
TIMER repeatedly to select a set period of
time (in minutes).
» When sleep timer is activated, is
displayed.
To deactivate sleep timer
1 Press SLEEP/TIMER repeatedly until
[SLEEP OFF] (sleep off) is displayed.
» When sleep timer is deactivated,
disappears.
Set the alarm timer
This docking system can be used as an alarm
clock. You can select CD, FM TUNER, iPod/
iPhone/iPad, or USB as alarm source.
Note
• Ensure that you have set the clock correctly.
1 In standby mode, press and hold SLEEP/
TIMER until [SET TIMER](set timer) scrolls
on the display.
2 Press CD, USB, DOCK, or FM to select a
source.
3 Press SLEEP/TIMER to conrm.
» The hour digits are displayed and begin
to blink.
4 Press / to set the hour, and then
press SLEEP/TIMER again.