Philips DTM3170 - Listen to an external device; Product information; Specifications

15EN
» The minute digits are displayed and
begin to blink.
5 Press / to set the minute.
6 Press SLEEP/TIMER to conrm.
» The alarm timer is set and activated.
Note
• To exit the alarm timer setting without storing, press
MENU/ .
Activate and deactivate the alarm
timer
In standby mode, press SLEEP/TIMER
repeatedly to activate or deactivate the alarm
timer.
» If the alarm timer is activated, is
displayed
» If the alarm timer is deactivated,
disappears.
Note
• If CD/USB/DOCK source is selected, but no disc is
placed or no USB/iPod/iPhone/iPad is connected, the
FM TUNER is selected automatically.
Listen to an external device
You can also listen to an external audio device
through this docking system.
1 Press USB/AUDIO IN repeatedly to select
audio in source.
2 Connect the supplied MP3 link cable to:
• the AUDIO IN jack on the unit
• the headphone jack on the device
3 Start to play the device. (See the device
user manual).
9 Product
information
Note
• Product information is subject to change without prior
notice.
Specications
Amplier
Maximum Output Power 150 W
Frequency Response 100 Hz - 16
kHz, ±3 dB
Signal to Noise Ratio >76 dB
AUDIO IN Input <600 mV RMS
Disc
Laser Type Semiconductor
Disc Diameter 12 cm/8cm
Support Disc CD-DA, CD-R, CD-
RW, MP3-CD
Audio DAC 24 Bits / 44.1 kHz
Total Harmonic
Distortion
<1%
Frequency Response 60 Hz -16 kHz (44.1
kHz)
S/N Ratio >65 dBA
Tuner
Tuning Range FM: 87.5 -
108 MHz
Tuning grid 50 KHz