Do you have a question about the Philips DVD963SA and is the answer not in the manual?
laser type | Semiconductor AlGaAs |
---|---|
numerical aperture | 0.60 (DVD), 0.45 (VCD/SVCD/CD) |
wavelength | 650 nm (DVD), 780 nm (VCD/SVCD/CD) |
medium | Optical disc |
---|---|
diameter | 12cm (8cm) |
playing time | One layer: 2.15 h, Dual layer: 4 h, Two side, single layer: 4.30 h, Two side, dual layer: 8 h |
power inlet | 110V, 60Hz |
---|---|
power usage | Approx. 20 watt |
power usage standby | Less than 4 watt |
signal-to-noise ratio | 115dB |
---|---|
dynamic range | 108dB |
crosstalk | 110dB |
total harmonic distortion | 100dB |
signal-to-noise ratio | 105dB |
---|---|
dynamic range | 105dB |
crosstalk | 105dB |
total harmonic distortion | 100dB |
YUV output | Y: 1 Vpp into 75ohm, CrCb: 0.7 Vpp into 75ohm |
---|---|
S-Video output | Y: 1 Vpp into 75ohm, C: 0.3 Vpp into 75ohm |
video output | 1 Vpp into 75ohm |
dimensions | 17 x 3.9 x 12.4 inches (w x h x d) |
---|---|
weight | 9.5 lbs |
carton dimensions | 20.6 x 8 x 15.7 inches (w x h x d) |
Specifies power requirements and usage.
General safety precautions for repair and use.
Specific warnings regarding hazards and precautions.
Step-by-step guide for disassembling the unit.
Visual representation of all parts for identification.
Advice and tips for servicing specific components.
Software for diagnosing DVD player hardware faults.
Tests module faults, reads error logs, and performs endurance loop tests.
Tests for the basic engine module, covering tray, disc motor, focus, etc.
Repeats dealer test nuclei indefinitely to check overall system behavior.
Details application errors logged in NVRAM for troubleshooting.
Error codes and descriptions for audio-related nuclei.
Overall block diagram of the DVD player's architecture.
Detailed wiring diagram showing interconnections between boards.
Schematic of the power supply unit.
Description of the switching mode power supply operation and output voltages.
Description of the loader/mono board, its functions, and components.
Description of the A/V board, its interfaces, and signal paths.
Describes the slave processor control, status LEDs, and AC display generation.