English
45
G To change the default recording settings,
press the matching colour coded button
on the remote control.
Red button - { Frequency }
Select the repeat recording setting
(Once, Weekly, Mon~Fri).
Green button - { Destination }
Select the destination for recording
(HDD or DVD).
Yellow button - { Timing }
Select adding extra time (+0, +10, +20,
+30) to the end of recording or select
VPS/PDC (V-P) function.
Note: VPS/PDC is not available for
external receiver.
H To exit, press TIMER (GUIDE Plus+).
The ‘TIMER’ icon lights up on the
display panel if a timer recording is set.
Helpful Hint:
– If the recorder is not in standby mode, a
noti cation message appears before the
timer recording begins. If you ignore the
message, the recorder automatically switches
to the respective channel and starts
recording.
– ‘VPS’ (Video Programming System) or
‘PDC’ (Programme Delivery Control) is used
to control the start and duration of TV
channel recordings. If a TV programme starts
earlier or ends later than was scheduled, this
recorder will then turn on and off at the
correct time.
Record TV Programme (continued)
Timer recording (manually)
A Turn on the TV to the correct viewing
channel for the recorder.
B Press TIMER (GUIDE Plus+) on the
remote control.
The GUIDE Plus+ screen appears.
Channels Home
C Press repeatedly to select { Schedule }
in the top menu bar.
Manual Home
VIDEO Plus+
No programmes
D Press the Green button on the remote
control for { Manual }.
The new timer entry menu appears.
Back HomeCancel
Freq. Dest. Timing
HDD
Once
No programmes
To Next Page
Loading...
