English
EN 27
Adjust settings
[ Analogue Output ]
Select the analogue audio setting based on
the audio device that is connected through
the analogue audio socket.
[ Stereo ]• – for stereo output.
[ LT/RT ]• – for surround sound output
through two speakers.
[ Digital Audio ]
Select the setting based on the digital
ampli er/receiver that is connected
through the digital socket.
[ Digital Output ]• – select the type of
digital output.
Option Description
[ Off ] Disable digital output.
[ All ] The device supports
multi-channel audio
formats.
[ PCM Only ] The device is not capable
of decoding multi-channel
audio. Audio is
downmixed to two-
channel sound: see
[
LPCM Output ]
setting.
[ LPCM Output ]• – select the LPCM
(Linear Pulse Code Modulation) output
sampling rate.
Option Description
[ 48kHz ] For discs recorded at
sampling rate of 48 kHz.
[ 96kHz ] For discs recorded at the
sampling rate of 96 kHz.
Note
[ LPCM Output ]• setting is only available if the
[ Digital Output ] is set to [ PCM only ].
The higher the sampling rate, the better the sound
•
quality.
[ Volume ]
Set the default volume level when you play
a disc.
Press 1. OK.
Press 2. b B to set the volume.
Press 3. OK to con rm and exit.
[ Sound Mode ]
Select a preset sound effect to enhance
the audio output.
[ 3D ]• – select a virtual surround sound
effect that is produced from the left and
right audio channels.
[ Movie Mode ]• – select a sound effect
for movies.
[ Music Mode ]• – select a sound effect
for music.
[ CD Upsampling ]
For better sound quality in stereo mode,
convert the music CD to a higher sampling
rate.
[ Off ]• – turn off CD-upsampling.
[ 88.2kHz ]• – convert to twice the
original sampling rate.
[ 176.4kHz ]• – convert to four times
the original sampling rate.
To Next Page
Loading...
